Hi,
Apologies to anyone using the woodshop this evening or tomorrow. I was routing some MDF and made a huge amount of dust. I swept and dusted as much as I could but couldn’t use the karcher vac as it had no bags, so will aim to come in Saturday morning to give it a hoover.
(it’s not too bad, just not the state I’d like to leave it in)
Thanks,
Pete
I think that @platinumnqueen22 was ordering bags and suggested if they were not ordered by Friday then I’d buy them myself and put in an expense claim?
I assume the order is in process now because I was not told what to buy?
It’s not that tricky, we just need to buy some bags 
They are in the space already.
On Thursday I told you and Brian that they’ve been bought, but just need to arrive. Which they did 
they are stored usually under the wood bench
Don’t recall you telling me and Brian said he was not sure so if they are there now then all good, I literally said to Brian on Thursday sitting at main table that if they had not been ordered then tell me what the part number was and I was going to order them so if I’d been told they had been ordered I would not have even made that comment?
It’s a million times easier to collect dust at source than clean up afterwards. Doesn’t the SLMC router not have a dust collection attachment that plugs into the tool?
I have my own router, at home (not inducted for router at the MS) and it does a pretty good job of collecting most of the dust.
Otherwise the stuff gets airborne and will make a mess everywhere. The router itself creates a lot of wind and blows the dust all over the place.