Ultimaker 3D printing warping on corners

Discussion
1

Good morning everyone.

For the last couple of times I’ve printed using the Ultimaker I’ve seen warping on the corners.

It was OK when I printed the morning after the last induction and from talking to other members apparently it’s OK after adjusting some of the settings, does anyone know what I might need to do to correct it?

2

I recalibrated the other week, I have the feeling that inductee tend to not calibrate the plate properly, I’m in tomorrow night an thursday, I wil l have a look at it

1 Like
3

Thanks, that’s appreciated.
If there’s something that I can check or do before prints in the future to check this before starting a print let me know.

4

I might leave a first later test on the SDcard

1 Like
5

Did you work out what the issue was?

6

Hi guys,

I printed with the ultimaker hours ago and there were no warping.
I had to recalibrate the plate because it was off, after that…no issues.

Thanks,
Federico

3 Likes
7

Thanks for checking that, hopefully it’s good to go from here on out.

1 Like